Thingiverse

E3D V6 Supercooling

von Br4ndosaurus

31 Downloads

28 Likes

1 Makes

Supercooling for your E3D V6! A 40mm heatsink fan and FOUR 40mm print cooling fans! Very aerodynamic and sleek, this flows exceedingly well. This snaps on to the heatsink quite tight! Made for my gearbest E3D V6 clone, but should also fit originals! The V6 heatsink shaft diameter is 22.27mm and the V6 heatsink height is 26.15mm. A bit of refining went into the inside to optimize flow and onto the outside to match aesthetically. Everything is supposed to be tight and solid once it's in its desired location. I would recommend printing the mount and the arms solid. This works like a dream for the heatsink and on full power the print cooling fans put out so much air it they down the heatblock! I only run mine at full power for bridging.

aero Aerodynamic cooling fan dual fan dual fan duct Dual Fan Mount E3D e3dv6 fan e3d fan e3d fan mount E3D v6 E3D Volcano four fan monster overkill print cooler print cooling fan quad fan supercooling tornado

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat