Thingiverse
Eachine E010 E010s Pro front camera mount (0.1g)
von MysteryDough
4
Downloads
2
Likes
0
Makes
Inspired by https://www.thingiverse.com/thing:2579328, this is a front camera mount for the Machine E010s Pro (shark body).
The mount is at 20 degrees and the camera is held on by a rubber band, but 3m foam tape would work just as well.
It's minimal and weighs in at 0.1g ( printed with PLA+ ).
And in case you're wondering, that's 2 hot glued 8inch zip ties as a roll cage.
The mount is at 20 degrees and the camera is held on by a rubber band, but 3m foam tape would work just as well.
It's minimal and weighs in at 0.1g ( printed with PLA+ ).
And in case you're wondering, that's 2 hot glued 8inch zip ties as a roll cage.
MysteryDough veröffentlicht auch auf
37 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
