Thingiverse
Eachine FPV mount adapter
von Excludos
7
Downloads
9
Likes
0
Makes
This is a adapter for the Eachine FPV. The screw holes for Eachine are 27mm apart while most other drones use 18-22mm sized holders. This simple adapter changes one size to the other, while staying clear of the stuff sticking out of the backside of the Eachine camera board.
The screw holes might need to be drilled up depending on how accurate your printer is. Use 1.5mm drill to do this, as 2mm will leave the screws loose in the hole.
Updated 26.01.16: After printing I noticed the cable sits rather tight towards the hole in the middle. I increased the size of the hole in v3. Everything else looked fine.
Updated 27.01.16: Often times it helps to actually highlight the object when exporting. Fixed file.
The screw holes might need to be drilled up depending on how accurate your printer is. Use 1.5mm drill to do this, as 2mm will leave the screws loose in the hole.
Updated 26.01.16: After printing I noticed the cable sits rather tight towards the hole in the middle. I increased the size of the hole in v3. Everything else looked fine.
Updated 27.01.16: Often times it helps to actually highlight the object when exporting. Fixed file.
Excludos veröffentlicht auch auf
9 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
