Eachine Wizard 220 top plate

The original creator did an amazing job producing this file. I wanted to continue using the side plates because I sometimes land in the grass and they keep the clipping out of the electronics. I added some width to the plate and the notches for the side plates. I moved the rear screw holes aft .5mm to line up better.

Update: 1-22-18 I was flying around upside down with this top plate (I set one of my quads up for inverted flying) and dumb thumbed it into the ground. The top broke. So the new replacement I put back on is more solid. I've just added the new file. Also in your slicer you can increase the thickness to your needs. I would suggest 2.5 to 3mm thick.