Eachine Wizard X220 Pod (R02)

Revision 02 - (05.04.18)
Revision 01 - (07.03.18)
Revision 00 - (28.02.18)

A pod I i’ve designed for the Eachine Wizard x220.

R02 now uses bolt + nut to secure it to the bottom plate (picture 9). This is much more robust than the previous method, but will require four M3 nuts.

I have also increased the height of the pod over the stack, it was quite tough to get the fs-ia6b receiver in here on the previous version (R01).

I also increased the diameter of the RX antenna holes, from 5.1mm to 5.3mm. It's hard to judge the correct diameter due to the variation in heat shrink on the antennae and the variation in 3D print quality. I suggest you put some hot glue on the antennae once fitted.

I have also added two versions this revision:
- without action cam holder
- with action cam holder

You should also be able to use the stock camera screws for mounting your fpv cam. This wasn't possible on earlier revisions.

Also, please see picture 10 on how to mount your fs-ia6b (o