Thingiverse
Eagle Tree Vector - Pitot Tube Mount
door markqv
110
Downloads
70
Likes
2
Makes
I needed a new way to mount the airspeed sensor (pitot tube) on one of my FPV planes. In this particular plane I am using an Eagle Tree Vector flight controller which was purchased in February 2015. Later versions of the Vector airspeed pitot tube might be different so make sure yours looks exactly the same as the one pictured.
There are two versions of this mount here. One which puts the pitot tube 32mm above the mount and m one which is 45mm above the mount. The 32mm version is shown in the pictures. You will need to print the file and a mirror copy of the file to get both halves.
I printed this in PLA+ but will re-do it in ABS to get the UV protection. The resolution was 0.1mm.
There are two versions of this mount here. One which puts the pitot tube 32mm above the mount and m one which is 45mm above the mount. The 32mm version is shown in the pictures. You will need to print the file and a mirror copy of the file to get both halves.
I printed this in PLA+ but will re-do it in ABS to get the UV protection. The resolution was 0.1mm.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!