Thingiverse
eap110-outdoor Wall mount
by nade74
9
Downloads
3
Likes
0
Makes
Wall mount for the TP-Link eap110-outdoor access point.
Tested on version 1 only, but should fit others.
The Top is probably not needed but can be used for extra security with m3x16 screws.
I printed it on 0.3mm cause for me it doenst have to be ultra good looking as u wont see much on it after attaching the access-point.
Tested on version 1 only, but should fit others.
The Top is probably not needed but can be used for extra security with m3x16 screws.
I printed it on 0.3mm cause for me it doenst have to be ultra good looking as u wont see much on it after attaching the access-point.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
