Slicer Discord
Earbud Earplugs – Modelo 3D imprimible de Thingiverse Thingiverse

Earbud Earplugs

112 Descargas
113 Likes
2 Makes
Ver Modelo
I ride a motorcycle, and as fellow motorcyclist will know, wind noise reaches hearing damaging levels. Many wear foam earplugs but this blocks out too much, I noticed that earbuds, block the wind but let most other things through almost unhindered, like car horns. Wearing earbuds is illegal, wearing earplugs is not, having a helmet audio system is not. So after installing a helmet intercom/audio system, I wanted the protection of earbuds without the cord.
I came up with these, they accept skull candy, and probably many other tips from earbuds.

They work quite well as Is although I was thinking about a tube down the middle and some sort of stuffing in the larger bulb section like cotton or something. To let higher frequency through but not the roar of the wind.

EDIT, I have been using these a while now and they work better than expected as is, the round part could probably be shorter to make taking helmet on and off easier, but they block almost all wind but let the helmet
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
¿Por qué?
impresión muy grande
Pieza única Puede necesitar escalado
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 3/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Cama mín.
300 mm (Muy grande)
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección