Thingiverse
earphone cable holder
von wintees
4
Downloads
5
Likes
0
Makes
a simple earphone holder to arrange the wire.
use it to wind the wire in an “Eighth loop”, put the top and the end of the wire into a gap. This way, the wire won’t be twisted as if if it lay flat on the ground.
there are four gaps, so it should be easier to fit in the wire.
special thanks to my brother who created this with me! ;)
use it to wind the wire in an “Eighth loop”, put the top and the end of the wire into a gap. This way, the wire won’t be twisted as if if it lay flat on the ground.
there are four gaps, so it should be easier to fit in the wire.
special thanks to my brother who created this with me! ;)
wintees veröffentlicht auch auf
15 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
