Thingiverse
Earphone case(with rotating lid)
di kaushikgunda
9
Download
12
Likes
0
Makes
This is an earphone case with a rotating lid that uses a SINGLE RUBBER BAND to open and it requires no screws. Open the lid just by pushing the lid towards the left and the lid fully opens. It gets locked when the lid closes.
REFER THE 4TH IMAGE TO UNDERSTAND THE ROTATION (DUE TO ELONGATION)
IN ODER TO THE ROTATE OF LID. BEFORE ASSEMBLING WITH THE RUBBER BAND THE CASE SHOULD LOOK LIKE 3 & 4TH IMAGE.
INSTRUCTIONS
Place the rubber band in the hook of the lid and the other end to the hook of LIDHOLDERP2.STL, before assembling refer the images that show the closed lid.
Assemble the parts as shown in images after the placement of the rubber band.
you are good to go!
Remember that the lid should be closed with the elongation of the rubber band. That means the lid should be in a retracting stage before assembling.
If the action of the rubber band is trying to close the lid.
disassemble the container.
Hold the lid holders with lid and rotate the lid to its end and assemble th
REFER THE 4TH IMAGE TO UNDERSTAND THE ROTATION (DUE TO ELONGATION)
IN ODER TO THE ROTATE OF LID. BEFORE ASSEMBLING WITH THE RUBBER BAND THE CASE SHOULD LOOK LIKE 3 & 4TH IMAGE.
INSTRUCTIONS
Place the rubber band in the hook of the lid and the other end to the hook of LIDHOLDERP2.STL, before assembling refer the images that show the closed lid.
Assemble the parts as shown in images after the placement of the rubber band.
you are good to go!
Remember that the lid should be closed with the elongation of the rubber band. That means the lid should be in a retracting stage before assembling.
If the action of the rubber band is trying to close the lid.
disassemble the container.
Hold the lid holders with lid and rotate the lid to its end and assemble th
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
