Thingiverse
earphone earbud holder
von frederikheytens
10
Downloads
10
Likes
0
Makes
This is an earbud holder i designed as a gadget.
It was lasercut in 3mm acrylic, but kan be 3d-printed as wel.
Version 2 is with a notch and can be used as a smartphone stand.
Version 3 resembles more like a music note .
(version 1 was not good)
The only remark i would like to make is that you have to wind the cord quite a few times.
But if i change that, it would be less like a music note.
It was lasercut in 3mm acrylic, but kan be 3d-printed as wel.
Version 2 is with a notch and can be used as a smartphone stand.
Version 3 resembles more like a music note .
(version 1 was not good)
The only remark i would like to make is that you have to wind the cord quite a few times.
But if i change that, it would be less like a music note.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!