Easier P1P Spindle Maintenance Cleaning GCODE

Note: This is a modified gcode so use at your own risk! This is only tested on the P1P printer! I'm sharing a small gcode which I created to make lead screw and spindle maintenance easier on the P1P.This gcode is fairly simple and in my honest opinion not dangerous at all. But since it is a modified code I have to warn you.You need to download the .zip file and import the .gcode on your microSD card. You can only start it from the printer.If you feel unsafe using this code the first time, keep a finger on the power switch while its running. What does this gcode do?Without heating the nozzle or hotbed it starts homing all axes as usual. All extruder commands were removed.Then it moves the hotbed up and down by 10mm, so the spindles turn once several times in both directions.The bed moves rapidly and warns that it is going to move up or down soon.You get about 2 minutes per cycle to clean the spindle (and apply new grease).After 4 cycles the bed moves almost fully up and almost fully dow