Easter egg candle holder

This is a neat easter egg candle holder for small 39mm diameter tea pot candles. Make sure you use a heat resistant filament since these candles can get pretty hot on the outside (>60°C). Tools needed: noneRecommended filament: PETG,GreentechPRO (heat resistant filaments strongly recommended)Hotend: 0,40mmPrint time:0,2mm Layer height: 3h 31minPrint instructions:layer height 0,20mm2 wall loopstop/bottom shells 5/3 layerstop/bottom shell thickness 0/1mmsparse infill 5%sparse infill pattern “gyroid”Before printing:Make sure your build plate is clean. Make sure to leave a review if you liked it.