Easy Bed Leveling Kit v02

Update:
added an explanatory picture as the term "leveling" seems to cause misunderstandings.

Bed-Leveling allways was a nightmare to me. I payed a lot of attention when I first assembled my printer, i leveled everything, starting with the desk where i built the machine on it.
But i allways had problems once everything was assembled or if everything was fine and i had to move my machine i had to start all over again...

So while i could bring it down to a point where i could print "smaller" parts i recently printed parts that needed the WHOLE printbed-area.
So i decided to put a finger on my problem which seemed to bee the 2 Y-Axis Guides not beeing 100% parallel and square, and to adjust this i designed these replacement for the fixed Smooth-Rod holder.

I got feedback on my version 01 and i wanted to address these inputs before i hit the 1'000 downloads mark so here it is.

Changes:

- increased width from 2mm to 3mm on the upper part as this could cause problems on