Easy Cable Management Clips

These cable management clips hold cables neatly and securely in place, yet let you easily add or remove cables when needed. It was inspired by a clip I used on the job years ago. Nobody knew who made them and everybody wanted some, so I went ahead and recreated it using OpenSCAD.

Several ready-to-print versions are included. Large will easily hold 24+ cat6 cables. Medium is good for about 8 cat6 cables or 6 line cords. Small will hold 2 cat6 cables or several smaller wires, small/tall is good for 3 cat6 cables and for bunching extra wire from a/c adapters. OpenSCAD source is included so you can customize to your heart's content.

If you customize, I recommend the open base/two screws option since it gives the clip more flex. If you are using double-side tape, go with closed back/no screws. Don't make the sides too thick as they will be too stiff and break off.

I printed mine in black ABS at 50% infill, 0.3mm layers, base down, no support. ABS has advantages here s