Thingiverse
Easy Camera Slider with or without motor
door dennisstu
159
Downloads
128
Likes
0
Makes
This is an easy camera slider with or without motor.
If you want the slider without motor, print the without motor part twice :)
Everything else you need is:
4 x M3 countersunk (20mm or 30mm)
2 x Ø 5mm ground wave (in the lenth you want the slider)
4 x linear bearings (LM5UU)
If you want the slider without motor, print the without motor part twice :)
Everything else you need is:
4 x M3 countersunk (20mm or 30mm)
2 x Ø 5mm ground wave (in the lenth you want the slider)
4 x linear bearings (LM5UU)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!