Easy Print Planter

SummaryThe Easy Print Planter is a self-watering planter that prints in one piece, WITHOUT supports! To use, pour water into the reservoir until the floater is 2 inches above the top of the pot. Don't forget to refill whenever the water-level floater dips below the top of the pot!Print SettingsPrinter Brand: Creality Printer: Ender-3 V3 SE Rafts: Doesn't Matter Supports: No Resolution: 0.2mm Infill: 70%Filament:Creality Hyper-PLA BlackPost-PrintingActivate Water Level Floater Simply push down lightly on the floater to break the small internal stick holding it in place, and you're good to go!