Thingiverse
Easy wall filament mount
von holidaay
1
Downloads
1
Likes
0
Makes
Designed from scratch in SW.
-Wall mounted
-Easy change of filament -just lift the spool up
-Filament clip on left side for 1,75mm filament
Uses 2pcs 608 bearings inside roller.
Notice: The tube needs to be scaled up on the height to your desired length. (It depends how far apart you want the sides. On the picture its 180mm.
-Wall mounted
-Easy change of filament -just lift the spool up
-Filament clip on left side for 1,75mm filament
Uses 2pcs 608 bearings inside roller.
Notice: The tube needs to be scaled up on the height to your desired length. (It depends how far apart you want the sides. On the picture its 180mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
