Thingiverse
EasyThreed Nano Spoolholder
1
Download
5
Likes
0
Makes
Spoolholder for Easythreed NANO.
You can print this on the NANO.
Very handy, for small (250 gr), big ( 1000 gr) or narrow (500 gr) spool.
1000 gr spool is a lot for the little NANO. But mine NANO print well with 1000 gr. Better. use low speeds with full rol..
You need 2 pieces of (at least) 16mm ( 5/8 inch) electricity tube (about 14 mm insite).
If you using ony small diameterspool of make only flat objects, you can use shorter electricity tube's. See foto's.
You can print this on the NANO.
Very handy, for small (250 gr), big ( 1000 gr) or narrow (500 gr) spool.
1000 gr spool is a lot for the little NANO. But mine NANO print well with 1000 gr. Better. use low speeds with full rol..
You need 2 pieces of (at least) 16mm ( 5/8 inch) electricity tube (about 14 mm insite).
If you using ony small diameterspool of make only flat objects, you can use shorter electricity tube's. See foto's.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
