Thingiverse
easythreed rod fix
por lonero
3
Descargas
3
Likes
0
Makes
this a fix for easythreed printer
install the rodfix on the top then raise the extruder up gradually untill
both side's get at same angle.
after that remove them.
note that i added atest fix so you can test your print if it fits since not most printers have the same parameters.
install the rodfix on the top then raise the extruder up gradually untill
both side's get at same angle.
after that remove them.
note that i added atest fix so you can test your print if it fits since not most printers have the same parameters.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!