Thingiverse
EBB42 mount for Afterburner
10
Downloads
5
Likes
0
Makes
This part can be mounted on the back of the NEMA42 motor using 4 countersunk M3 screws of ~18mm long. The EBB Canbus board is mounted a bit higher up so it clears the dragchain.
The dragchain is mounted into 3 M3 heatset inserts.
The EBB does not supply 24V to the endstop connector, so I had to solder a wire to the CAN connectors 24V pin to power the Omron sensor.
The dragchain is mounted into 3 M3 heatset inserts.
The EBB does not supply 24V to the endstop connector, so I had to solder a wire to the CAN connectors 24V pin to power the Omron sensor.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!