Thingiverse
EC-17 Blaster Stand
di Whifflesauce
32
Download
18
Likes
0
Makes
Couldn't find a blaster stand design for an EC-17 Blaster, so I made one.
Hello pathfinders, here is a simple stand to display your prestigious hold-out blaster. Keep it ready, keep it safe, and keep those Rebel scum at bay!
This was designed to hold the blaster I have, some blasters are made smaller than others. For sizing the front post is 52 mm tall and the rear stabilizers are 65 mm behind the post.
Info plate is a separate file, change filament to make text pop!
There is an off centered hole in post to accommodate a screw holding my trigger guard in place. The posts on the plate may need some clean-up/adjusting to sit in the holes, but it should lean back at a slight angle.
The blaster pictured and used for designing this stand was purchased from Darth Voorhees on the 501st pathfinder forum.
Hello pathfinders, here is a simple stand to display your prestigious hold-out blaster. Keep it ready, keep it safe, and keep those Rebel scum at bay!
This was designed to hold the blaster I have, some blasters are made smaller than others. For sizing the front post is 52 mm tall and the rear stabilizers are 65 mm behind the post.
Info plate is a separate file, change filament to make text pop!
There is an off centered hole in post to accommodate a screw holding my trigger guard in place. The posts on the plate may need some clean-up/adjusting to sit in the holes, but it should lean back at a slight angle.
The blaster pictured and used for designing this stand was purchased from Darth Voorhees on the 501st pathfinder forum.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
