Echo Dot 4th-5th Generation Tie Fighter Stand

I broke this up into parts to print without supports. I did run into a little issues with cockpit, but it cleaned up with a snip of the clippers where the bridging failed a little. I had to sand the panels down to fit so you could toy with shrinking them a tiny tiny bit. Also I would avoid using super glue. I tied super glue at first and it drys white. Instead I used a Multi-purpose adhesive I found on amazon called B-7000. Good Luck and if anyone prints please post a pic. Thanks to the original creator and remixer Cookiemonster1112 and RemRem74.

Also I included a part called caps that was supposed to go on the center outside of the wing but I decided I did not like them and left them off mine.