Thingiverse
Echo Dot Gen3 Microphone
by hillbille
38
Downloads
31
Likes
0
Makes
Although many parts are listed, and included, this piece prints with only 5 parts. There are several "extra" parts included which allow the end user (You) to use several different sprinkler pipes. This allows you to use what's on hand instead of buying. The pipe is NOT included as it is such a cheap and easy piece to buy - and cut to length, that I did not make a printable one. This is very simple and easy to print and assemble. No supports are needed for any of the pieces. Have fun!
Parts list:
G2_2_G3_Adapter.stl - Adapter ring to use a Gen2 Dot in this model.
G3_microphone_back_half_v2.stl - The rear section of the microphone shell.
***
G3_microphone_Dome_75.stl - The base for the microphone stand - built in 3/4" sprinkler pipe adapter.
G3_microphone_Dome_50.stl - The base for the microphone stand - built in 1/2" sprinkler pipe adapter.
Only ONE of these needs printing - depending upon the size pipe used.
***
G3_microphone_front_half_v2.stl - The front sec
Parts list:
G2_2_G3_Adapter.stl - Adapter ring to use a Gen2 Dot in this model.
G3_microphone_back_half_v2.stl - The rear section of the microphone shell.
***
G3_microphone_Dome_75.stl - The base for the microphone stand - built in 3/4" sprinkler pipe adapter.
G3_microphone_Dome_50.stl - The base for the microphone stand - built in 1/2" sprinkler pipe adapter.
Only ONE of these needs printing - depending upon the size pipe used.
***
G3_microphone_front_half_v2.stl - The front sec
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
