Eclips3d adjustable Z Endstop

This is an adjustable Z endstop for the Eclips3d printer, with a handy wire run on the bottom for the heat bed wires.

First loosen the bolt on the z-collar and slide adjuster into place. Tighten the bolt back on, you might need to keep a finger on the adjuster as the bolt cuts threads into the plastic.

Second, I recommend manually raising the bed to touch the heat end, with what ever surface you've installed on the bed. Then raise the adjuster to trigger the endstop. Tighten the screw to lock it into place.

Lastly, level your bed.