Slicer Discord
Ecos use counter – 3D-Druckmodell von MakerWorld MakerWorld
Board Games

Ecos use counter

2 Downloads
1 Likes
3 Makes
Zum Modell
This is a use counter for a boardgame Ecos (https://boardgamegeek.com/boardgame/279254/ecos-first-continent). I always had an issue with the card usage counting mechanic in this game (you rotate the card to match number of remaining uses on the top edge), as it makes it harder to keep track what your cards do, especially for new players. We used six sided dice with success for this purpose, but they are bit cumbersome as you have to always find the side with on less pip. These counters have only four sides in successive decrements, so you only rotate them to the next visible (from your POV) and lower denomination. The plate has 4x12 pieces, which is more than enough for most four player games, we usually have between 4 and 8 cards active on the board, so it should suffice even in six player game. The counters have a hole for a 16mm M4 screw so that it is heavier and harder to flip accidentally (also why it has 100% infill). Exact dimensions of the hole are 16x4.5mm bottom tube, 4x8.5mm
Kategorie
Board Games
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Warum?
Print-in-place-Design
Print-in-place Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen