ECX circuit servo saver

Noticed the steering was getting very sloppy on my ECX Circuit stadium truck so I quickly knocked up and printed a new servo saver steering block. Steering is now spot on!

I'd probably say PLA may be a bit stiff for this job and liable to snap if you smack the front wheels hard enough or not provide enough give to save the servo.......but I could be wrong!

printed in ABS at 100% infill, no supports needed, only takes a few minutes to print and slower is better. may need some slight adjustment with a round/half round needle file to get the best fit. if it's way too tight increase X&Y axis by a couple of % to get you in the ball park.