EDC Calipers 2.0 (mm)

This is an improvment to my previous model found here : https://makerworld.com/en/models/1310855-edc-calipers-metric#profileId-1345110 After reading the main issues faced by the previous model I decided to make the calipers more robust to differnent material tolerances. This new design has a spring mechanisim that holds the caliper firmly in place this spring mechnaisim was validated using a cantilever beam analysis similar to the one done here :https://makerworld.com/en/models/733605-buckle-with-engineering-calculations#profileId-682925 Along woth the updated mechanisim I also added slots for 6 mm x 2 mm magnets so that this caliper can be magnetically attached to my slim moft magsafe tripod. If the moft one is too expensive this one I found on amazon shouljd also work : https://www.amazon.com/EWEMDAI-Magnetic-Stain-Resistant-Adjustment-Multifuctional/dp/B0CSBR2Z51/ref=sr_1_22_sspa?crid=26BW3ZPXSRTR7&dib=eyJ2IjoiMSJ9.UJ7dN2QcYSII7YV-8bKQfwBy-2aTlfUH4xqlaJJkFy_xAdofGfkDWqNU4-O_WN9HOrLV