Edgeswitch 8pt single mount

I'll be honest: I didn't spend a lot of time on this model. I had a situation where I needed to mount a ToughSwitch to a wood board only 4 inches wide, with the top pointed up, so the two-piece mount I started with wouldn't do as well. This quick remix just adds a hanging section with screw holes and supports on the far side.

I may go back some day and measure better how wide I can make those supports before getting in the way of airflow, and add recesses for the screw heads. But for now this worked for a quick-n-dirty mounting bracket that no one will ever see, until I can justify spending more time on it.

For printing settings, the screw holes are your limitation on resolution. If you can get clean screw holes at .2mm, you'll better that way for strength. Everything else is straight up & down vertically. But if you need .1mm to get clean screw holes, you should still be fine; the print will just take longer. There should be no need for raft or brim with this print.