MakerWorld
Hueforge & Lithophane
Go to Model
Eevee Evolution Jolteon Hueforge
37
Downloads
46
Likes
15
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x199.87mm in sizeYou may print at higher layer heights below the Min Depth of 1.4mmThe Max Depth is 3.3mm and the Actual Depth is 3.4mmFilaments Used: PLA BambuLab Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Matte Mandarin Orange Transmission Distance: 3 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA BambuLab Matte Lemon Yellow Transmission Distance: 4This print uses 5 unique filamentsSwap Instructions: Start with Black At layer #20 (1.68mm) swap to Blue Gray At layer #23 (1.92mm) swap to Mandarin Orange At layer #32 (2.64mm) swap to Yellow At layer #37 (3.04mm) swap to Lemon YellowBorder Only Colors from here until the end. At layer #40 (3.28mm) swap to Yellow for the rest. Artist: Sarah Richford - eeveelutions Jolteon
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
