EFLITE Apprentice S15e and STS Wheel Pants

Wheel pants for EFLITE Apprentice STS and S15e. Front pant top is slid over metal axle, wheel is secured and then the bottom clips into the top. I did different colours as I liked the look and wanted to show the different parts. The rear tops and bottoms are glued together. They snap onto the landing gear wire. I used PLA as I like the finish better. Printed at 70 degree supports. The rear struts printed pretty well except for the underside near the top. Supports would have made the clip slot a pain to clean out though. Tested in flight. Might have thrown the CG to the rear a bit but it still flies great. Think they add a lot aesthetically.