Thingiverse
Egg for Vase Mode
von abbymath
119
Downloads
121
Likes
3
Makes
This model was designed for printing in vase mode for Easter. The bottom is rather flat to avoid needing supports. The idea is to drop in some coins or other surprises while it prints. Since the egg is in vase mode with thin walls, it is easy to break open to find the surprise.
This idea was inspired by the need to create more eggs for our at-home Easter Egg Hunt next week. It is Spring 2020 and people everywhere are staying home to ride out the storm of COVID-19 and grocery stores are limiting what people can purchase. Our eggs are precious these days and we wanted an alternative to hard boiling and dyeing eggs that our kids won't eat later.
Tip: Probably best not to fill with chocolate or other things that can melt.
Also see my
- [Easter Egg Pendants](https://cults3d.com/en/3d-model/jewelry/easter-egg-pendants)
- [Easter Egg Magnets](https://cults3d.com/en/3d-model/home/easter-egg-magnets)
------
Model is approximately 41 x 41 x 60 mm. I printed using "Single outline
This idea was inspired by the need to create more eggs for our at-home Easter Egg Hunt next week. It is Spring 2020 and people everywhere are staying home to ride out the storm of COVID-19 and grocery stores are limiting what people can purchase. Our eggs are precious these days and we wanted an alternative to hard boiling and dyeing eggs that our kids won't eat later.
Tip: Probably best not to fill with chocolate or other things that can melt.
Also see my
- [Easter Egg Pendants](https://cults3d.com/en/3d-model/jewelry/easter-egg-pendants)
- [Easter Egg Magnets](https://cults3d.com/en/3d-model/home/easter-egg-magnets)
------
Model is approximately 41 x 41 x 60 mm. I printed using "Single outline
abbymath veröffentlicht auch auf
95 zusätzliche Modelle auf 3 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
