Egg holder (extensible and customizable)

I have been looking for an egg holder that meets **all** the following requirements:
- can hold at least 10 eggs,
- fits into a refrigerator door compartment (-> not deeper than 100mm),
- keep the eggs stable and safe when removing the entire holder from the refrigerator and
- can be produced with a standard heatbed (200x200mm).

Because I didn't find such a model, I designed it myself.

A single holder measures 50x100mm and holds two eggs.
Several holders can be connected together in a very stable way.

The printing time for a single holder (two eggs) is almost exactly one hour, 16g filament are needed (@my printer/configuration).
Up to four holders can be easily positioned on a 200x200mm heatbed and thus printed in a single job.

The eggs must have a maximum diameter of at least 35mm in order not to slip through the holder.
If necessary, the parameters can be adjusted in the **Customizer**.

To remove a single egg, lift it from the bottom with a finger.

BTW: For a