Thingiverse
egg holder for refrigerator
von muriloluizg
32
Downloads
39
Likes
0
Makes
This is a egg holder for refrigerator modeled on Thinkercad.
It was printed with PLA.
Support needed but is better if you print upside down and with hollow support with support interface on.
Hope enjoy it!
End Caps for Open V-Slot 2020 with Open Hardware logo.
This is a remix from https://www.thingiverse.com/thing:398515
It was printed with PLA.
Support needed but is better if you print upside down and with hollow support with support interface on.
Hope enjoy it!
End Caps for Open V-Slot 2020 with Open Hardware logo.
This is a remix from https://www.thingiverse.com/thing:398515
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
