Thingiverse
Music
Go to Model
Egg Shaker
5
Downloads
9
Likes
0
Makes
Recommended: Print with flat surfaces facing down on the build plate.
Minimum Recommended Print Settings:
– Supports: Enabled
– Support Type: Tree supports
– On Build Plate Only: Enabled
– Threshold Angle: 20
Note for Threshold Angle: You can increase this number to add more supports. A setting of 20 may leave slight imperfections inside the egg, but it doesn’t seem to impact sound quality. A setting of 35 or higher will create too many supports, which are difficult to remove.
Minimum Recommended Print Settings:
– Supports: Enabled
– Support Type: Tree supports
– On Build Plate Only: Enabled
– Threshold Angle: 20
Note for Threshold Angle: You can increase this number to add more supports. A setting of 20 may leave slight imperfections inside the egg, but it doesn’t seem to impact sound quality. A setting of 35 or higher will create too many supports, which are difficult to remove.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
