Eggmobile for Bambu Lab LED Lamp Kit

PLEASE READ THE INSTRUCTIONS BEFORE PRINTING.This lamp depicts my design for the Eggmobile, hoisting the Master Emerald away from a crystal base.No pilot is in the driver's seat; you can put your own figure in the chair if it is small enough. The materials used are found below.Silver - Bambulab PLA Matte GreyBlack - Bambulab PLA MatteYellow - Bambulab PLA MatteGreen - Prusament PLA Green OpalBlue - Prusament PLA Royal Blue BlendCyan/Teal - Bambulab PET-G Translucent Teal The “Base” of the lamp is identical to the one provided by BambuLab in the original LED Lamp Kit: https://makerworld.com/en/models/13717#profileId-13429 The BambuLab LED Lamp Kit, or something of a similar size, is required to use this item as a lamp. Because of this, it prints pretty small (approximately 9-10cm tall).SUPPORTS ARE REQUIRED.I have pre-painted the support zones and configured the settings appropriately for printing on an X1C. There are a lot of supports to remove, so I recommend PVA or other easy-to-