EGO Broom Wheel Frame

This is a frame for adding wheels to your EGO broom. Mine is the EGO Multi-head, it has a 25mm shaft. It has a ½" axle hole for ½" smooth rod, available at most hardware stores. I used 2) 7" plastic wheels, any type of wheel with a ½" hole should be fine. I held them on with 2) ½" collars (also readily available at a hardware store). If you are taller, (I'm 5' 8") you may benefit from a larger wheel to raise the handle a bit more. You will also need some bolts or screws, I used 4) 6Mx45 screws. I tapped the lower hole, but I'm not sure if that was necessary. I've used it once and it seems like it will be strong enough. I printed it with PLA 4 walls and 25% gyroid infill.