EIBOS Dryer Deflector

Created this after discovering that my filament dryer was overheating the underside of the filament roll and warping/bonding the filament.
The larger of the two files is a single piece design but too large form me to print on my printer.
The smaller design is what I used and what is depicted in the photos shown here.
It takes two if you plan to have two rolls of filament in the dryer, but would work as a single with one roll.
I used a CF/Nylon Filament as I am sure that PETG and certainly PLA would warp in use.
(Updated Information)
From the comments (you can read here) it is apparent the any of the higher temperature filament choices is adequate to use as a shield. That includes PETG and ASA