Eibos Polyphemus Removable Lid

I took @falcon1441 original model split it, added alignment pins and so the top and bottom lid portions would be able to print on my Bambu Lab P1S. A little glue between the pinned parts keeps it real nice while bolting everything up. Once bolted together its super solid.Print in PETG for strength and temperature resistance. Most of the information below is from the original designer:Putting the whole lid + expansion to pieces, assemble it in reverse, putting the expansion on the top, and not the bottom. You can also eliminate using the expansion pieces if you do eliminate the expansion the small panel outlined in the paragraph below is not needed and you could feed to your printer through the original top holes in the acrylic lid.Small panel to replace one of the expansion's acrylic panel, providing 3 filament outputs with PC4-M10 PTFE mounts. Some 6x3mm magnets are added to the caps and replacement panel to seal off filament outputs when not in use. A new top lid assembly, where