Eight faces Buddha planter

Inspired from the Buddha bust scan from 3DWP I create this eight faces Buddha planter.

There are three versions:

* without drainage
* with drainage in the middle to use with the saucer
* with drainage on the side for outdoor

I think the best usage is outdoor in a huge size.

Currently it is a bit small, 80 x 81 x 87mm. You have to upscale by yourself. Check all layers before print it because some single points in the wall are only one nozzle diameter wide. For outdoor usage (maybe indoor too) I suggest to use a wide nozzle or paint it inside (with resin or similar) to make it more waterproof if needed.

I guess there is no support needed if you print it accurate. But not sure.

I just remixed it for fun. My test make you can found here: https://www.thingiverse.com/make:550829

And I must say this model get on the limits of tinkercad. I had to do some workarounds to build it. Maybe some details went lost. Anybody has connections there? I need more cpu power and the po