Thingiverse
Ejection Handle for DCS
door Met25
3
Downloads
3
Likes
0
Makes
Simple ejection handle for DCS, use a micro switch secured by two screws into the "switch block" and a 3 way switch on the arm plate.
use a strong spring secured to the top handle using a long bolt and nyloc and another spring underneath in the retention plate to allow it to return to center but still allowing to to freely swivel.
for the handle use some type of rope and have the knot inside of the plunger/handle top, ive used some stainless TIG wire to stiffen it up.
use a strong spring secured to the top handle using a long bolt and nyloc and another spring underneath in the retention plate to allow it to return to center but still allowing to to freely swivel.
for the handle use some type of rope and have the knot inside of the plunger/handle top, ive used some stainless TIG wire to stiffen it up.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
