Thingiverse
El Stompo Diablo
door schlem
44
Downloads
44
Likes
0
Makes
Not much to say here. You either know what this is, or... you don't. If you do, print it with high infill for strength (I used 60%). To attach it, get some 3M automotive double stickum known as "3M Super Strength Molding Tape"
___
**ATTENTION**
This work is licensed under the [Creative Commons - Attribution - Non-Commercial license](http://creativecommons.org/licenses/by-nc/3.0/). This license applies only to the files and documents available for download from the **Thing Files** section of this Thing.
**All other related content (photographs, videos, and verbiage such as contained in "Description" or "Instructions" ) are excluded from this license, with all rights reserved, unless specifically available for download** This notice constitutes a clarification, not a change, to licensing for this design.
___
**ATTENTION**
This work is licensed under the [Creative Commons - Attribution - Non-Commercial license](http://creativecommons.org/licenses/by-nc/3.0/). This license applies only to the files and documents available for download from the **Thing Files** section of this Thing.
**All other related content (photographs, videos, and verbiage such as contained in "Description" or "Instructions" ) are excluded from this license, with all rights reserved, unless specifically available for download** This notice constitutes a clarification, not a change, to licensing for this design.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
