EL Wire Shooting Star

Similar to my other EL Wire Star ornament but larger and with a tail. This Star uses about 1.5 Metres of EL Wire, this is what I used in 3 M length and cut off the excess. I had to split the model in two parts for my printer so there is a Star and Tail with matching notches and tabs for alignment, just use a bit of CA Glue to firmly hold it together.To assemble, just feed all the wire through the hole from the bottom first, do one layer of the middle section of the tail first, then do the outside of the tail, next two layers around the star. I used a few dabs of CA glue to make it easier.