Elecom Deft Pro Power Switch and Conversion

A power switch replacement for Elecom Deft Pro trackball mouse with additional angle conversion part if you replace the DIP switch with the top actuated version.

Elecom Deft Pro use a side-actuated MSK-23D18 DIP switch from Vimex to toggle between off/low/high power setting. This DIP switch will wear down over time, causing the trackball to occasionally become irresponsive. However, I can't find the exact same switch for sale within my area, so I settle with MSS-23D18 that is the top-actuated version of MSK-23D18, and since the pin position is different, I designed a conversion part that need to be attached on top of the original power switch.

Parts:

Use MSLA/SLA 3D printer only, since the parts are very small.

Assembly:

If you need to use the conversion part, you may want to use a power glue to attach the conversion part to the top of the power switch for a more secure fit, but this means you will need to destroy and replace the power switch if you ever need to replace the DIP s