Electrastim Case

This is a custom holder for an Electrastim Flick stimulation device.

To finish this build you will have to print the clamp.stl twice

You will need:
4 x M3 bolts to attach the lid onto the box
2 x M5 bolts to attach the body to the clamp support
4 x M4 bolts to screw the clamp sections in
4 x M4 nuts. These go in the slots at the back on the clamp support. Unfortunately they tore the plastic on mine so I had to use glue to stop them spinning when tightening the M4 bolts

There are some better videos/pictures of the device in use on my twitter which may help show you the assembly a bit better if anything is confusing