Thingiverse
Electric Guitar Stand
von Howard_Ni
7
Downloads
9
Likes
1
Makes
1. The stand can matching with 5cm thickness of eletric guitar-body.
2. There are rubber notch design on the stand so you can paste rubber into notch after print.(suggest use thickness 3 or 4 mm rubber sheet)
2. There are rubber notch design on the stand so you can paste rubber into notch after print.(suggest use thickness 3 or 4 mm rubber sheet)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
