Thingiverse
Engineering
Go to Model
Electronic card
7
Downloads
5
Likes
0
Makes
Inspired by https://www.youmagine.com/designs/ultimaker-heated-bed-mosfet-relay-hack-v2, this is an electronic circuit used to switch an electric strike. The circuit is equivalent to a relay but uses a MOSFET.
The card is printed with the 3D printer and the electronic components are inserted in the holes. Then you have to solder the components using their legs or wires (see the picture). The screw-block must be glued to the card.
The card is designed with OpenSCAD. It shoud be easy to design other (simple) electronic circuits using this method.
The card is printed with the 3D printer and the electronic components are inserted in the holes. Then you have to solder the components using their legs or wires (see the picture). The screw-block must be glued to the card.
The card is designed with OpenSCAD. It shoud be easy to design other (simple) electronic circuits using this method.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
