Thingiverse
Electronics Mock-up Station
por jsmwrench
0
Descargas
2
Likes
0
Makes
A project build station for Arduinos, ESPs, Raspberry Pi's, etc. Stores 3 different controllers and has space for small and standard solderless breadboards. It has 5 storage drawers including a long one for dupont wire storage.
The control board panels are printed in PETG and are designed for 5mm long PCB threaded, brass standoffs with bolts. Everything else can be printed in PLA.
I tinker with microcontrollers and liked having a mock-up station, but most of the ones you can purchase lay flat on the workbench. That always made it difficult for me to see the exact pin I was trying to connect to. This station is positioned at 45 degrees, making it easier to see all of the pins. I made it for my own use, but thought I would share it in case others found it interesting.
Printed on a Bambu X1C.
0.2 layer height, 3 walls, 25% rectilinear infill, supports in only to areas (see photo attached.
The control board panels are printed in PETG and are designed for 5mm long PCB threaded, brass standoffs with bolts. Everything else can be printed in PLA.
I tinker with microcontrollers and liked having a mock-up station, but most of the ones you can purchase lay flat on the workbench. That always made it difficult for me to see the exact pin I was trying to connect to. This station is positioned at 45 degrees, making it easier to see all of the pins. I made it for my own use, but thought I would share it in case others found it interesting.
Printed on a Bambu X1C.
0.2 layer height, 3 walls, 25% rectilinear infill, supports in only to areas (see photo attached.
jsmwrench también publica en
11 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
