Electronics Terminal Block

I was looking at ways to better manage my wiring for a new printer build and thought "Hey, some terminal blocks would be darn handy". I found a severe lack of decent ones on here so I decided to throw a snazzy one together right quick.

This handy dandy little terminal block comes in two pieces and 8 pre-made sizes. It's designed to work with standard m3 bolts and nuts. all that is required to assemble is a soldering iron and possibly a knife for cleaning up the edges.

Assembly instructions:

Print off both the top and bottom sections
.
Make sure the top can nest into the channels of the bottom.If your printer is over extruding or a little messy there could be a bit of shmoo to clean up with a knife.

Once it is nesting just fine use a soldering iron to press the m3 nuts into the premade slots of the bottom. Attach the top to the bottom and then use the end holes to screw it into whatever you like ( note, I'm not responsible for you screwing it into inappropriate things, o