Thingiverse

Electroplating Wand

von Kickbut101

21 Downloads

13 Likes

0 Makes

Wand for electroplating. Snake a wire through the center and wrap it around the notches on the spatula. Throw some tinfoil wrapped a few times around the spatula (over the top of the wire) and then apply the cotton strips and a rubber band. Voila all good to go.

I printed it laying down with support to hold the spatula up. How I have it sitting on my table in the picture is how I printed it.

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Warum?

Supports nötig

Einteilig Supports nötig

Supports 2/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker